This assignment is required to use multiplexer method that should be designed in the (Multisim 12.0) program. See page 4 . All details of the assignment is available in the PDF file. However, if you see the last two pages, you will find two Electronics logic boards. The reason of these two boards is after you finish the design, we are required to work on it. These two boards are available in Labs Therefore, the component that you are going to use it (In the Multisim 12.0 ) should be available in the two boards. After you finish the design, the output should be similar to the picture (by using the Oscilloscope).

Also I will send to you my design that is not working very well.

Make sure, your should work on the multiplexer method and use component that Dr. explained by using (Multisim 12.0)